Date: Thu, 5 Feb 2004 15:35:33 +0100 From: "Søren Steen" <none@s_steen--ofir.dk.lh.bsd-dk.dk> To: bsd-dk novice <none@bsd-novice--bsd-dk.dk.lh.bsd-dk.dk> Subject: Ingen opstart efter installation af OpenBSD 3.3
Hej
Jeg har haft et problem med at jeg ikke kunne ping domaine navne men kun ip
adr.
Jeg oprettede derfor et spørgsmål her på listen "Problemer med navneopslag på
OpenBSD 3.3", men fik ikke rigtig brugbare resultater ud af det.
Nå, så jeg valgte at installerer det hele om igen. Jeg bruger en
installationsvejledning som jeg selv har noteret ned og har brugt den med held
et par gange efterhånden. Men ikke denne gang.
Min maskine indeholder bl.a. et raid controller kort 3ware 7000-2, hvor der er
sat 2 diske til i et spejl. Det ser ud til at virke godt nok.
Når installation starter op finder den raid kortet godt nok. Og den opretter
også filsystemer på diskene senere i installationen. Så kortet og diskene
skulle virke godt nok. Der er slet ikke rørt ved noget hardwaremæssigt siden
sidste installation bortset fra at jeg har ophævet spejlet og gendannet det
igen, inde i BIOS på raid kortet.
Jeg har gået med nogle tanker om at problemet kunne være at der noget der ikke
var sat aktivt, så computeren ikke ved hvor den skal starte med at lede efter
en opstartsfil. Men jeg håber I kan komme med nogle hint.
Jeg installerer maskinen på følgende måde:
---------------- Installation start --------------------
(I)nstall, (U)pgrade or (S)hell? I <Retur>
Terminal type? [vt220] <Retur>
Do you wish to select a keyboard encoding table? [n] y <Retur>
Select your keyboard type: (P)C-AT/XT, (U)SB or 'done' [P] p <Retur>
Table name? (or 'done') [us] dk <Retur>
Proceed with install? [n] y <Retur>
Available disks are: sd0.
Which one is the root disk? (or 'done') [sd0] <Retur>
Do you want to use *all* of sd0 for OpenBSD? [no] <Retur>
fdisk: 1> p m <Retur>
fdisk: 1> e 1 <Retur>
Partition id ('0' to disable) [0 - FF]: [0] (? for help) a6 <Retur>
Do you wish to edit in CHS mode? [n] y <Retur>
BIOS Starting cylinder [0 - 4864]: [0] <Retur>
BIOS Starting head [0 - 254]: [0] <Retur>
BIOS Starting sector [1 - 63]: [0] 1 <Retur>
BIOS Ending cylinder [0 - 4864]: [0] 4864 <Retur>
BIOS Ending head [0 - 254]: [0] 254 <Retur>
BIOS Ending sector [1 - 63]: [0] 63 <Retur>
fdisk:*1> p <Retur>
fdisk:*1> p m <Retur>
fdisk:*1> f 1 <Retur>
Partition 1 marked active.
fdisk:*1> p <Retur>
fdisk:*1> w <Retur>
Writing MBR at offset 0.
fdisk:*1> q <Retur>
> d a <Retur> #Kun hvis disken er brugt før
> a a <Retur>
offset: [0] <Retur>
size: [5606685] 10G <Retur>
Rounding to nearest cylinder: 305235
FS type: [4.2BSD] <Retur>
mount point: [none] / <Retur>
> db <Retur> #Kun hvis disken er brugt før
> a b <Retur>
offset: [20964825] <Retur>
size: [5301450] 500M <Retur>
Rounding to nearest cylinder: 1028160
FS type: [swap] <Retur>
> d d <Retur> #Kun hvis disken er brugt før
> a d <Retur>
offset: [21992985] <Retur>
size: [4273290] 120M <Retur>
Rounding to nearest cylinder: 240975
FS type: [4.2BSD] <Retur>
mount point: [none] /tmp <Retur>
> d e <Retur> #Kun hvis disken er brugt før
> a e <Retur>
offset: [22233960] <Retur>
size: [55922265] 10G <Retur>
Rounding to nearest cylinder: 20964825
FS type: [4.2BSD] <Retur>
mount point: [none] /var <Retur>
> d g <Retur> #Kun hvis disken er brugt før
> a g <Retur>
offset [43198785] <Retur>
size: [34957440] 10G <Retur>
Rounding to nearest cylinder: 20964825
FS type: [4.2BSD] <Retur>
mount point: [none] /usr <Retur>
> d h <Retur> #Kun hvis disken er brugt før
> a h <Retur>
offset: [64163610] <Retur>
size: [13992615] 4G <Retur>
Rounding to nearest cylinder: 8385930
FS type: [4.2BSD] <Retur>
mount point: [none] /home <Retur>
> p m <Retur>
> q <Retur>
No label changes.
The root filesystem will be mounted on sd0a.
sd0a will be used for swap space.
Mount point for sd0d (size=120487k)? (or 'none' or 'done') [/tmp] <Retur>
Mount point for sd0e (size=10482412k)? (or 'none' or 'done') [/var] <Retur>
Mount point for sd0g (size=10482412k)? (or 'none' or 'done') [/usr] <Retur>
Mount point for sd0h (size=4192965k)? (or 'none' or 'done') [/home] <Retur>
Mount point for sd0d (size=120487k)? (or 'none' or 'done') [/tmp] done <Retur>
Are you really sure that you're ready to proceed? [no] y <Retur>
#Installation klargøre diskene
system hostname? (short form, e.g. 'foo') serv1 <Retur>
Configure the network? [y] <Retur>
Available interfaces are: em0 xl0 xl1.
Which one de you wish to initialize? (or 'done') [em0] xl0 <Retur>
Symbolic (host) name for xl0? [serv1] <Retur>
Do you want to change the default media? [n] <Retur>
IP address for xl0? (or 'dhcp') 192.168.0.5 <Retur>
Netmask? [255.255.0.0] 255.255.0.0 <Retur>
Available interfaces are: em0 xl1.
Which one de you wish to initialize? (or 'done') [em0] <Retur>
Symbolic (host) name for em0? [serv1] <Retur>
Do you want to change the default media? [n] <Retur>
IP address for em0? (or 'dhcp') 10.0.0.1 <Retur>
Netmask? [255.255.0.0] 255.255.255.0 <Retur>
Available interfaces are: xl1.
Which one de you wish to initialize? (or 'done') [xl1] <Retur>
Symbolic (host) name for xl1? [serv1] <Retur>
Do you want to change the default media? [n] <Retur>
IP address for xl1? (or 'dhcp') 172.17.0.1 <Retur>
Netmask? [255.255.0.0] 255.255.0.0 <Retur>
Done - no available interfaces found.
DNS domain name? (e.g. 'bar.com') [my.domain] s_steen.local <Retur>
DNS nameserver? (IP address or 'none') [none] 212.54.64.170 <Retur>
Use the nameserver now? [y] <Retur>
Default route? (IP address, 'dhcp' or 'none') 192.168.0.1 <Retur>
add net default: gateway 192.168.0.1
Edit hosts with ed? [n] <Retur>
Do you want to do any manual network configuration? [no] <Retur>
Password for root account? (will not echo) #skriv password <Retur>
Password for root account? (again) #skriv password igen <Retur>
Sets can be located on a (m)ounted filesystem; a (c)drom, (d)isk or (t)ape
device; or a (f)tp, (n)fs or (h)ttp server.
Where are the install sets? (or 'done') c <Retur>
Abailable CD-ROMs are: cd0.
Which one contains the install media? (or 'done') [cd0] <Retur>
#Installationen leder efter cd-rom'en.
Pathname to the sets? (or 'done') [3.3/i386] <Retur>
#Der bliver vist en liste over de ting der er mulig at installere. De ting som
vil blive installeret som standard er der sat kryds ved. Jeg vil ikke have
"game33.tgz" med, så derfor gør jeg:
File name? (or 'done') [bsd.rd] - game33.tgz <Retur>
File name? (or 'done') [bsd.rd] done <Retur>
Ready to install sets? [y] <Retur>
#Selve installationen køres.
Sets can be located on a (m)ounted filesystem; a (c)drom, (d)isk or (t)ape
device; or a (f)tp, (n)fs or (h)ttp server.
Where are the install sets? (or 'done') done <Retur>
Do you expect to run the X Window System? [y] n <Retur>
What timezone are you in? ('?' for list) [US/Pacific] ? <Retur>
What timezone are you in? ('?' for list) [US/Pacific] Europe <Retur>
What sub-timezone of 'Europe' are you in? ('?' for list) ? <Retur>
What sub-timezone of 'Europe' are you in? ('?' for list) Copenhagen <Retur>
halt
---------------------------- Installation slut -----------------------
På forhånd tak.
Mvh.
Søren.
_________________________________________________________________________
OFiR Spil - Vind 1.000 vis af kroner! Besøg http://spil.ofir.dk
OFiR Kontakt - Find din nye ven el. partner på http://kontakt.ofir.dk
This archive was generated by hypermail 2b30 : Wed 15 Nov 2006 - 18:25:09 CET