wpa_supplicant opsætning TDC

From: Mic J (none@michael.cognacc--gmail.com.lh.bsd-dk.dk)
Date: Wed 02 Sep 2009 - 20:46:30 CEST 

Date: Wed, 2 Sep 2009 20:46:30 +0200
Subject: wpa_supplicant opsætning TDC
From: Mic J <none@michael.cognacc--gmail.com.lh.bsd-dk.dk>
To: bsd-dk <none@bsd-dk--bsd-dk.dk.lh.bsd-dk.dk>

Hej

mine forældre har lige fået et produkt kaldet tdc box ( kombineret
TV, internet, Ip telefoni )

De har en router med WPA2 som jeg prøver at forbinde med
wpa_supplicant.

godkendelse WPA/WPA2
kryptering TKIP/AES
Blandet netværk b/n/g
WPA type: passphrase

Jeg har lavet passphrase key (?) udfra den given fra tdc
# wpa_passfrase essid passphrase

min wpa_supplicant.conf 

---
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=wheel
ctrl_interface_group=0

network={
         ssid="MY_SSID"
         scan_ssid=1
         # 'RSN' == 'WPA2'
         #proto=RSN WPA
         proto=WPA2
         # that's 'pre-shared key'
         #key_mgmt=WPA-PSK
         key_mgmt=WPA-EAP
         # lists ciphers to try. CCMP is AES
         # pairwise is for client  AP traffic, group is for broadcasts
         pairwise=CCMP TKIP
         group=CCMP TKIP
         #psk=passphrase
         psk=passphraseTranslated(wpa_passfrase)
         }

---
Jeg har obskureret psk passphrase og ssid.

Er der nogen der kan spotte noget jeg mangler.
eller har en opsætning som virker.

Jeg ved ikke helt hvad det er for en router vi har fået.
sagem 3564 TDC VDSL2

jeg kører arch linux på denne maskine, men wpa_sup.. skulle være det
samme på bsd og linux.

debug output fra wpa_suuplicant
---
[run@arch_t60p ~]$ sudo wpa_supplicant  -B -Dwext -i wlan0 -c
/etc/wpa_supplicant.conf -ddd
Initializing interface 'wlan0' conf '/etc/wpa_supplicant.conf' driver
'wext' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
ctrl_interface='DIR=/var/run/wpa_supplicant GROUP=wheel'
ctrl_interface_group='0'
Line: 15 - start of a new network block
ssid - hexdump_ascii(len=8):
      $hexnumbers                         MY_ESSID
scan_ssid=1 (0x1)
proto: 0x2
key_mgmt: 0x2
pairwise: 0x18
group: 0x18
PSK - hexdump(len=32): [REMOVED]
Priority group 0
   id=0 ssid='MY_ESSID
Initializing interface (2) 'wlan0'
Interface wlan0 set UP - waiting a second for the driver to complete
initialization
SIOCGIWRANGE: WE(compiled)=22 WE(source)=21 enc_capa=0xf
  capabilities: key_mgmt 0xf enc 0xf flags 0x0
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:1c:bf:8a:99:6a
wpa_driver_wext_set_wpa
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wpa_driver_wext_set_drop_unencrypted
RSN: flushing PMKID list in the driver
Setting scan request: 0 sec 100000 usec
WPS: UUID based on MAC address - hexdump(len=16): 59 90 38 56 7b 9b 5b
fe 88 33 2c 02 57 01 a3 d7
WPS: Build Beacon and Probe Response IEs
WPS:  * Version
WPS:  * Wi-Fi Protected Setup State (0)
WPS:  * Version
WPS:  * Wi-Fi Protected Setup State (0)
WPS:  * Response Type (2)
WPS:  * UUID-E
WPS:  * Manufacturer
WPS:  * Model Name
WPS:  * Model Number
WPS:  * Serial Number
WPS:  * Primary Device Type
WPS:  * Device Name
WPS:  * Config Methods (0)
WPS:  * RF Bands (3)
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
ctrl_interface_group=10 (from group name 'wheel')
Added interface wlan0
Daemonize..
---
Det er især de der EAPOL linier jeg tænker måske er et  problem.
For mig ser det ud som om det virker.
Men når jeg kører.

sudo dhcpcd wlan0 (svarer til dhclient)
Siger den.
---
dhcpcd: version 5.0.7 starting
dhcpcd: wlan0: waiting for carrier
dhcpcd: timed out
---

Michael

This archive was generated by hypermail 2b30 : Wed 30 Sep 2009 - 23:00:01 CEST